General Description; Survey; Functional Description; Extent Of The Delivery - Grizzly ET 3500 Translation Of The Original Instructions For Use

equipment. Avoid body contact
with earthed parts (e.g. metal
fences, metal posts).
• Only use extension cables with
a maximum length of 75 m that
have been approved for open-air
use. The stranded cord diameter
of the extension cable must be
at least 2.5 mm
a cable drum to its full length
so that the entire cable can be
inspected for damage.
• Never pass an operating equip-
ment over the extension cable.
Ensure that the power cable is al-
ways trailing behind the operator.
• Use the envisaged cable
suspensions when attaching
an extension cable.
• Never carry the equipment by its
power cable. Never pull the cable
to disconnect the plug from the
mains socket. Protect the cable
from heat, oil and sharp edges.

General description

The illustration how to handle the
appliance can be found on page 2.

Survey

1 ON / OFF switch
2 Handle
3 Strain relief
4 Power cable
5 Telescopic tube
6 Screw sleeve to adjust the
length
7 Motor head
8 Protection cover
9 Cutting head
10 Line spool (not visible)
11 Line cutter
. Always unreel
2

Functional description

The portable, hand-guided lawn trimmer
is powered by an electric motor. The trim-
mer features a dual line spool with a tap
mechanism as the cutting device.
For grass trimming there are two nylon
lines rotating parallel with ground level.
An additional chassis facilitates edge trim-
ming. A hood covering the cutting device
protects the user.
The following describes the functions of
the operating parts.

Extent of the delivery

Carefully unpack the trimmer and check
that it is complete:
• Lawn trimmer
• Protection cover with 2 screws
• Instruction Manual

Assembling instructions

Always disconnect the plug be-
fore working on the trimmer and
wait until the cutting lines have
completely stopped. There is the
danger of electric shock and the
possibility of injury by the cutting
lines.
Fitting the Protective Cover:
1. Push the protective cover (8)
into the guide rail on the bottom
of the motor housing (7).
2. Fix the protective cover with both
screws (14).
Adjusting the height:
3. The telescopic tube enables
you to adjust the trimmer to your
height.
GB
19