Raven RS1 Installation Manual page 14

Hide thumbs Also See for RS1:

Table of Contents

CHAPTER 3

4. Remove the 12-pin connector housing from the cable to fit the cable through the roof gland and center hole.

FIGURE 3. Cable Routed Through Roof Gland and Center Hole

5. Fit the roof gland assembly as shown in Figure 4.

FIGURE 4. Roof Gland Assembly

6. Mount the roof gland with the supplied self-drilling screws.

7. When mounted, tighten the black ring to prevent water and dirt into the roof gland.

FIGURE 5. Dustcap with Lanyard

Fendt Varioguide RS1 Installation Manual

Table of Contents