Table of Contents
Advertisement
ALERT – HART Devices Count Exceeded
Description:
More HART devices were detected on the wired connection that the VECTOR V1100
supports. Not all of the HART devices will be connected to the Wireless Network.
Corrective Action:
Remove HART devices from the wired connection to the amount supported by the VECTOR
V1100.
Timestamps:
Start: Set the first time that too many HART devices were detected.
Stop: Same as the start time.
ALERT – HART Sub-Device Lost
Description:
A sub-device connected to the VECTOR V1100 has stopped communicating and has been
dropped from the sub-device list.
Corrective Action:
If the sub-device was removed intentionally, clear the alert. Else, check the connection /
power to the sub-device and verify communications with a wired-HART handheld or PC.
Timestamps:
Start: Set when the sub-device was lost.
Stop: Same as the start time
ALERT – Burst Packets are Being Dropped
Description:
One or more burst packets have been dropped from the VECTOR V1100 to the wireless HART
network.
Corrective Action:
Check to ensure that the wireless HART network has granted the requested bandwidth for
the burst settings. If not, either adjust the wireless HART network settings or adjust the
VECTOR V1100 burst times.
If the burst messages being dropped are for a wired sub-device, ensure that there are no
other HART masters on the connection, as these can cause burst message delays.
33
Advertisement
Table of Contents
