Basic Operation - GE Masoneilan VECTOR V1100 Instruction Manual

Wirelesshart adapter
Table of Contents

Advertisement

GE Oil & Gas
Low cost / low risk means to test and evaluate wireless HART networks.
Substitute for multiplexers or legacy DCS upgrade to HART enabled I/O.
External Battery powered wireless remote I/O data collection.
Features:
HART Registered - fully HART compliant for communication reliability.
Universal connectivity - works with all registered HART devices
Supports wireless HART MESH and STAR network configurations.
Loop powered - no batteries or other power sources required.
Connects directly to HART field device and optionally anywhere on the 4-20 mA control
loop.
StepVolt technology sets insertion voltage in steps from 1 to 2.5 V to manage the
tradeoff between available loop power and wireless communication bandwidth.
Direct Power option when local DC power is available: system power, external battery/
solar system.
In Direct Power mode, can switch field device on/off to take periodic readings to save
power.
Internal 250 Ohm loop current sense resistor provided, configurable by wireless HART
command.
Multidrop support for up to eight devices (maximum number depends on installation).
235 meters open air range (nominal).
Rugged internal antenna design.

Basic Operation

The VECTOR V1100 wireless HART Adapter allows new and existing wired-HART devices to be
integrated into a wireless HART network. This allows remote access to diagnostic data, digital
process variables, and alarm data stored inside HART devices.
The VECTOR V1100 has both a wireless interface to communicate with the wireless HART
network and a wired-HART interface to communicate to a traditional 4-20mA current loop
device. The VECTOR V1100 communicates as a wired-HART master to connected HART
devices on the loop, and can transmit and receive HART data from these connected HART
devices to the wireless HART network. The VECTOR V1100 also supports configuration as a
wired-HART slave device, so traditional HART configuration tools (such as HART Field
Communicators and PCs with HART modems) can be used to configure the VECTOR V1100.
VECTOR V1100 Wireless Adapter
10

Advertisement

Table of Contents
loading

Table of Contents