Western Digital OpenFlex Data24 DCS0010 User Manual page 70

User Guide
Step 5 : Uninstall the remaining Rails in the same way the first was uninstalled.
Step 6 : Install the rack mount Rails.
a. Determine which of the rails is the right and which is the left as shown in the following
image.
Figure 84: Rails Identification
b. From the rear of the rack, set the rear of the Rails in the same location as the damaged Rails
and extend it so that the pins fit into the same U holes.
Figure 85: Rails Location
c. Secure the rear of the rack mount Rails to the rack using the T15 Torx screwdriver, install the
two M5 Torx screws that secure the rear of the rack mount Rails to the rack.
3. Support
3.7 Rails Replacement
63