Western Digital OpenFlex Data24 DCS0010 User Manual page 49

User Guide
ESD Mitigation Equipment (site specific)
• ESD Sensitive
• Electric Shock
• Fan Blade Danger
Step 1 : Unpack and inspect the new System Fan for damage.
a. Inspect the packaging that the System Fan replacement was shipped in and record any
damage to the box. Large cuts, open boxes, and crushed corners should be reported.
b. Remove the System Fan from the packaging and verify that there is no damage to the
System Fan. Dents, scratches, and broken parts should be reported. If major damage has
occurred to the System Fan, DO NOT use the replacement part.
c. Store in a safe location until the System Fan is needed for installation.
Step 2 : Extend the platform out of the rack to access the System Fan bay.
a. From the front of the rack, using the T15 Torx screwdriver, loosen the two Torx captive
screws that secure the Chassis to the rail. Repeat this step to loosen the two Torx captive
screws that secure the Chassis to the remaining rail. The location of the captive screws are
shown in the following image.
Figure 49: Rack Ear Captive Screw Location
Tool
T15 Torx Screwdriver
3.4 System Fan Replacement
# Needed
1
1
3. Support
Required vs.
Recommended
Required
Required
42