Western Digital OpenFlex Data24 DCS0010 User Manual page 43

User Guide
Figure 37: Drive Assembly Installation
Step 16 : Install the remaining Drive Assembly in the same way the first was installed.
Step 17 : Connect the power and data cables to the enclosure.
a. Loop the PSU's retention clip around the power cable and pinch it until the clip catches and
locks in place.
Figure 38: Locking the Retention Clip
b. Slide the retention clip forward until it stops near the cable connector. Doing this will ensure
that the retention clip functions properly in the event the cable is accidentally pulled.
3. Support
3.2 Chassis Replacement
36