Western Digital OpenFlex Data24 DCS0010 User Manual page 30

User Guide
Step 1 : Unpack and inspect the new Chassis for damage.
a. Inspect the packaging that the Chassis replacement was shipped in and record any damage
to the box. Large cuts, open boxes, and crushed corners should be reported.
b. Remove the Chassis from the packaging and verify that there is no damage to the Chassis.
Dents, scratches, and broken parts should be reported. If major damage has occurred to the
Chassis, DO NOT use the replacement part.
c. Store in a safe location until the Chassis is needed for installation.
Step 2 : Disconnect the power and data cables from the enclosure.
a. Unclip the retention strap as shown in the following image.
Figure 14: Unclipping Cable Retention Strap (Generic PSU Shown)
b. Move to the rear of the rack and disconnect the power cables from each of the two Power
Supply Unit (PSU).
Figure 15: Disconnect Power Cables
c. Disconnect the Ethernet Cable from the RJ45 Ethernet Management port.
3. Support
3.2 Chassis Replacement
23