Getting Started: Uio Stick Software - Infineon BTN7030-1EPA User Manual

Motor Control Shield for Arduino with BTN7030-1EPA
4.1.2

Getting started: uIO Stick Software

 Install Infineon Toolbox

Connect the uIO Stick between the USB port of your PC and Infineon uIO Stick port (Figure 1) on the
Arduino shield.
Figure 8 uIO Stick

Under Manage Tools find Config Wizard for Single Half-Bridges and install it
 When you open this Config Wizard you can configure the Shield according to your preferences and see
SENSE and OUT current waveforms, Figure 9.
 Important to remember is that it is only possible to plot SENSE and OUT current of the IC1 on the board.
This limitation exists due to the configuration of the 16-pin uIO Stick port.
User Manual
or lightweight Launcher
13 Rev. 1.0
2021-01-21