7.
In the [Device Addressing] tab, set the devices, offsets
*1 A start address of the device to be used.
Name
Control
Status
Input Block
Output Block
Command
Command Result
For details on the data block, refer to the following manual.
Vision Sensor Connection Guide
8.
Click the [OK] button.
When the following message appears, click the [Yes] button to restart the vision system.
9.
Select [Sensor] [Network Settings].
10.
Check that "SLMP Scanner" is selected in the "Industrial Ethernet Protocols" in the "Network Settings" screen, click the
[Settings] button.
2 BASIC OPERATIONS FOR SPREADSHEET
52
2.8 Establishing Communication
Selected device
D - Data Register
D - Data Register
D - Data Register
D - Data Register
D - Data Register
D - Data Register
*1
, and number of devices for each data block as follows.
Offset
0
2
100
200
300
400
Number of devices
100
100
100
100