Safety Precautions - Demtech Pro-X5 600-0105/X5/A Operator's Manual

Rev. A: January 2015

Safety Precautions

Safety precautions for operating personnel and equipment:
WARNING 1: Operating personnel should perform only the procedures described and recommended in
this manual. Only qualified service personnel familiar with electrical shock hazards and mechanical
entanglement hazards present inside the equipment should perform disassembly or corrective maintenance
of the equipment.
WARNING 2: To avoid shock hazards, the equipment must be grounded with an adequate earth ground in
accordance with local and national electrical codes.
WARNING 3: The locations of potentially dangerous voltages and other hazards are identified and labeled
on the equipment. Be careful to observe these warnings when installing, operating, maintaining or servicing
the equipment. Observe all warnings in this manual.
WARNING 4: Make sure to turn off the equipment power and remove the ~ (AC) line cord from the power
outlet before attempting to service the equipment. Do not perform service unless you are qualified and
trained to do so.
WARNING 5: This product is intended for operator attended operation only. This product should never
be left unattended at any time while it is plugged in and the power is turned on. Incorrect use of the product
such as overheating of the material can present a fire and explosion hazard, especially near combustible
materials and explosive gases.
WARNING 6: This product is intended for operation in dry environments only. Higher humidity
environments should be kept non-condensing by avoiding large temperature swings.
WARNING 7: Do not touch the main housing, air nozzle and output molten material when they are hot as
they can cause burns. After use allow ample time for the product to tool cool down before handling and
stowing. Do not point the hot air flow and the output molten material in the direction of personnel.
CAUTION 1: Observe the precautions given on the equipment and within this manual to prevent damage
to the equipment.
CAUTION 2: Before connecting the equipment to its electrical source, check that the ~ (AC) voltage,
frequency and current to be supplied to the equipment are correct and match the serial plate affixed to the
welder.
CAUTION 3: Use proper handling and packaging procedures for Electro-Static Discharge (ESD) sensitive
circuit boards. Assume that all circuit boards are sensitive to potential damage from ESD.
CAUTION 4: Unauthorized personnel should not remove from the equipment those panels that are
provided for protection and/or require a tool to remove.
vi Pro-X5 Operator's Manual 600-Manual_Pro-X5 RA.docx