Factory Servicing; Welder Wiring Diagram - Demtech Pro-X5 600-0105/X5/A Operator's Manual

c. Clean any residual melted plastic material from the Teflon Shoe Assembly and Nozzle to
facilitate and ease reinstallation of the new Shoe.
d. Install the new Teflon Shoe Assembly in the reverse order.

8. Factory Servicing

In the event your Pro-X5 should require factory service, the entire welder needs to be returned to
DEMTECH Services, Inc. or to your authorized DEMTECH distributor where the product was
purchased. Refer to the following steps for preparing the Pro-X5 for return.
Carefully pack the Pro-X5 in the reusable portable shipping/storage case provided with the welder
for return to DEMTECH Services, Inc. or to your authorized DEMTECH distributor where the
product was purchased. Unless previous arrangements are made, shipping charges and insurance
are the customer's responsibility. Ship the Pro-X5 to DEMTECH Services, Inc. at:
or to your authorized DEMTECH distributor where the product was purchased.

9. Welder Wiring Diagram

Refer to Diagram 9.1 for the Pro-X5 Welder Wiring Interconnect Diagram.
Page 18
DEMTECH Services, Inc
Ship to address: 6414 Capitol Avenue
Diamond Springs, CA 95619
U.S.A.
Pro-X5 Operator's Manual
Rev. A: January 2015
600-Manual_Pro-X5 RA.docx