Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
B
R
UMPER
EPLACEMENT
3)
Insert and securely seat the replacement sonars
into the cover.
4)
Connect the sonar cables and replace the cover.
5)
Complete the Sonar Sensor Service Test.
22.2 Bumper Replacement
NOTE: Left side cut-away view of cover shown.
1)
Remove the cover.
2)
Disconnect the bumper cable from the bumper.
3)
Remove the bumper retaining screws.
2
1
1 – Bumper cable
2 – Bumper retaining screw (11X)
4)
Remove the bumper assembly.
70
5)
Assemble the new bumper assembly to the
cover.
6)
Assemble the bumper retaining screws, tighten
to 1.5 lbf• ft (2 N•m).
7)
Connect the bumper cable to the bumper.
8)
Complete the Bumper Service Test.
22.3 Front Lift Cushion
Replacement
NOTE: Detail of left side shown.
1)
Remove the collecting wheel access hatch.
2)
Remove top and bottom screws and washers.
3)
Assemble the new front cushion kit in the original
location.
4)
Assemble top and bottom washers and screws,
tighten to 4.5 lbf•ft (6 N•m).
5)
Complete the Lift Sensor Service Test.
1 – Top screw
2 – Top washer
3 – Cushion kit
1
2
3
4
5
Advertisement
Table of Contents
