Automatic Transmission Fluid And Oil Filter - Mitsubishi FUSO FH 1997 Service Manual

LUBRICATION

Automatic Transmission Fluid and Oil Filter

Ê Tightening torque
Location
4
Drain plug
5
Dipstick guide connector
6
Bolt (Oil pan mounting)
8
Bolt (Oil filter mounting)
12
Oil filter
- Fluid
Location
11
Body of O-ring
12
Gasket of oil filter with thin application
B
A
01-32
Parts to be tightened
Points of application
[Inspection and replenishment]
• Park the vehicle on level ground, make sure that the parking brake is
1
• Start the engine and let it idle. To fill the hydraulic circuit with auto-
2
• While the engine is still idling, pull out dipstick 1 and wipe off the fluid
• If the fluid level is inspected right after the engine is started and the
13920
• If the fluid level is inspected after the vehicle has been driven and the
WARNING–
NOTE
• Make sure the vehicle is parked on level ground when you are
• Make sure the range selector lever is in the N position and the
• Be sure to wipe off the dust from the safety cap and the upper
2
• To ensure the fluid is correct, reinspect the fluid level after an
• If the fluid level is low, add automatic transmission fluid (DEXRON or
13923
Tightening torque
20 to 27 {15 to 20, 2.05 to 2.75}
125 to 135 {91 to 100, 12.55 to 13.76}
14 to 18 {10 to 13, 1.4 to 1.8]
14 to 18 {10 to 13, 1.4 to 1.8]
9.8 to 20 {7 to 14, 1 to 2}
Automatic transmission fluid
(DEXRON or DEXRON II type)
Automatic transmission fluid
(DEXRON or DEXRON II type)
fully activated and chock the wheels to keep them from rolling.
matic transmission fluid, shift the range selector lever from N → R → N
→ D → 2 → D → N. Repeat this process five times, finally shifting to N.
sticking to it. Reinsert the dipstick, then pull it out again and check the
fluid level.
fluid temperature is still low (approximately 15 to 49°C {60 to 120°F}),
the level should be within area A marked COLD on dipstick 1.
fluid temperature is high (approximately 71 to 93°C {160 to 200°F}),
the level should be within area B marked HOT on dipstick 1.
Take care during the inspection because the engine will be run-
ning. Take sufficient care to avoid burns or injuries resulting
from contact with moving parts.
checking the fluid level.
engine is idling when you are checking the fluid level. When the
engine is stopped, the fluid level appears higher than it actually
is.
part of dipstick guide 2 before you pull out dipstick 1.
actual drive.
DEXRON II type) through dipstick guide 2 until the correct level on
dipstick 1 is reached.
Unit : N·m {lbf.ft, kgf·m}
Remarks
Specified fluid
—
—
—
—
—
Quantity
As required
As required