Mitsubishi FUSO FH 1997 Service Manual page 18

Put alignment marks on part combinations before disassembly and ar-
range the disassembled parts neatly. This will help avoid mismating of
the parts later.
Put the alignment marks, punch marks, etc. where performance and
appearance will not be affected.
Cover the area left open after removal of parts to keep it free from dust.
CAUTION–
• Take care to avoid mixing up numerous parts, similar parts, left
and right, etc.
• Keep new parts for replacement and original (removed) parts
00017
separate.
Apply the specified oil or grease to U-packings, oil seals, dust seals and
bearings during assembly.
Use only the specified oil, grease, etc. for lubricant, remove the excess
immediately after application with a piece of waste, etc.
CAUTION–
When the specified lubricant, fluid and sealant is not available,
you may use an equivalent.
00018
Wear goggles when using a grinder or welder. Pay full attention to safety
by wearing gloves when necessary. Watch out for sharp edges, etc. that
might injure your hands or fingers.
00019
Before carrying out maintenance work on the electric system, disconnect
the negative terminals of the batteries to prevent them from short-
circuiting and burning-out.
CAUTION–
Be sure to turn starter and lighting switches, etc. off before
disconnecting or connecting battery terminals, because the semi-
conductors can be damaged.
14184
00
00-9