Table of Contents
Advertisement
2
1
F
[Supply]
• Pour fluid into power steering oil tank 1 up to the inner port of strainer
5.
5
• With the engine stopped, jack up the front wheels and turn the steer-
ing wheel fully left and right repeatedly. When the fluid level has
dropped, add fluid to maintain the fluid level within range A.
A
NOTE
Check the fluid level without screwing on filler cap 2.
12604
• Start the engine and letting it idle, turn the steering wheel fully left and
right repeatedly. When the fluid level has dropped, add fluid to maintain
the fluid level within range A. Repeat these steps until the fluid level
does not drop.
• If there is an abnormal noise, air is still in the system. Turn the steering
wheel several times to raise the fluid temperature to approximately 60
to 80°C {140 to 176°F}, then stop the engine and wait for approximately
five minutes.
• Lower the front wheels and turn the steering wheel several times. If
there is no noise, bleeding is completed.
• When bleeding is finished, check fluid level of power steering oil tank
1, and pipe and hose connections for fluid leakage.
01
01-37
Advertisement
Table of Contents
