Table of Contents
Advertisement
Ê Tightening torque
Location
Parts to be tightened
2
Bolt (Flywheel mounting)
- Lubricant and sealant
Location
2
Thread area of bolt
11
Lip area of rear oil seal
Crankcase mounting surface of rear oil seal
A
7
8
A
B
Points of application
7
Service procedure
[Inspection]
7
(1) Wobble
If the measured value is higher than the limit, check the fastening of
bolt 2, the attachment surface of crankshaft assembly, and depending
on the condition found, either repair or replace flywheel assembly 7.
2
12718
(2) Height of friction surfaces
If the measured value is lower than the limit, repair or replace flywheel
assembly 7.
A
7
A :
03349
(3) Distortion of friction surface
If the measured value is lower than the limit, repair or replace flywheel
assembly 7.
NOTE
If any fault is found in ring gear 8, replace it first, then begin
the inspection.
03350
[Correction]
Make sure when grinding the friction surfaces for correction, that height
A is not lower than the limit while maintaining the degree of parallel with
A
surface B within 0.1 mm {0.0039 in.}.
03351
Tightening torque
39 {29, 4} +45
Engine oil
Engine oil
THREEBOND 1207C
Flywheel assembly
Height from bolt mounting surface to friction surface
Unit : N·m {lbf.ft, kgf·m}
Remarks
o
o
5
Wet
Kinds
As required
As required
As required
11
Quantity
11-49
Advertisement
Table of Contents
