Table of Contents
Advertisement
2
A
B
4
5
3
< Section at
< General
protruded
section >
area >
< Front >
< Rear >
1
0
A
[Inspection and replenishment]
Inspect the level of the brake fluid in fluid tank 1. It should fall between
the "L" and "H" levels. If it is below the "L" level, remove cap 2 from the
fluid tank, then supply the specified brake fluid until the level comes up to
the "H" level. Do not fill above the "H" level.
2
1
04852
• If diaphragm 3 is not in its normal posture when the brake fluid is
supplied, correct it to its normal posture, and install cap 2. If brake fluid
leaks from the cap area after you have supplied brake fluid, check
whether the diaphragm is assembled as illustrated.
4 :
Slide ring
5 :
Ring cover
A :
Correct condition of diaphragm when brake fluid is being supplied
B :
Condition when diaphragm is extended when brake fluid has
decreased
01679
[Replacement]
• Start engine and let it idle until brake fluid replacement is completed.
• Attach one end of 0 vinyl hose to air bleeder 1 and place the other
end in container A.
1
0
A
04865
04866
01
01-39
Advertisement
Table of Contents
