Installation In To A Factory Built (Metal) Fireplace - Breckwell SP24i Owner’s Instruction And Operation Manual

E. INSTALLATION IN TO A FACTORY BUILT (METAL)
FIREPLACE
When installing into a factory built fireplace, the firebox
must accept the insert without modification other than
removing bolted or screwed together pieces such as smoke
shelf/deflectors, ash lips, screen or door tracks and damper
assemblies. These items must be reinstalled to restore the
fireplace to its original operating condition if the insert is
removed and not replaced. The removal of any part must
not alter the integrity of the listed fireplace in any way. The
factory built fireplace must be listed per UL 127. Installation
must include a full height listed chimney liner meeting type
HT requirements (2100° F) per 1777 (U.S.). The liner must
be securely attached to the insert flue collar and the chimney
top. The damper area must be sealed to prevent room air
passage to chimney cavity. Alteration of the fireplace in
any manner is not permitted except with the following
exceptions:
• External trim pieces, which do not affect the operation
of the fireplace, may be removed proving they can be
stored on or within, the fireplace for re-assembly if the
insert is removed.
• The fireplace damper may be removed to install the
chimney liner.
Circulating air chambers, louvers or cooling air inlet or outlet
ports (i.e. in a steel fireplace liner or metal heat circulator)
shall not be blocked. Means must be provided for removal
of the insert to clean the chimney flue. A permanent metal
warning label must be attached to the back wall of the
fireplace opening stating the following:
© 2020 Breckwell Hearth
• This fireplace has been altered to accommodate a
fireplace insert and should be inspected by a qualified
person prior to re-use as a conventional fireplace.
• This label is available upon request.
Final approval is contingent on the authority having
jurisdiction.
VERTICAL CAP
STORM COLLAR
THE SMOKE SHELF
MAY BE REMOVED
12"
NOTE: THE LOG SHELF,
SCREEN, AND DOORS
(IF PRESENT) MUST BE
REMOVED
USE THE ZERO
CLEARANCE SKIRT
OR ADJUSTABLE
LEGS ON RAISED
FIREPLACES
THE MASONRY LINING
MAY NOT BE REMOVED
12
INSTALLATION
COVER PLATE
(NON-COMBUSTIBLE)
SEAL WITH SILICONE
3" OR 4" L-VENT OR
STAINLESS STEEL
FLEXIBLE OR SINGLE
WALL PIPE
THE DAMPER MAY BE
REMOVED
INTERNAL BAFFLES
MAY BE REMOVED
TO PREVENT
FIREPLACE ODORS
FROM ENTERING THE
HOME, PAINT THE
INTERIOR OF THE
FIREPLACE WITH
LATEX PAINT
THE METAL SIDES,
FRAME MEMBERS, OR
OTHER STRUCTURAL
COMPONENTS OF THE
FACTORY BUILT
FIREPLACE MAY NOT
BE REMOVED OR
ALTERED