Installation; Specifications; Floor Protection - Breckwell LUXURY SERIES SP2700 Owner's Manual

SPECIFICATIONS

Width: 23 1/8"
Height: 30 ½"
Depth: 22 ¼"
Weight: 233 lbs.
Flue size: 3" or 4"
Hopper Capacity: Up to 50 lbs.
(This can vary widely depending on pellet size,
length, and diameter)
EPA status: exempt
Burn time: 1 lb. to 5.5 lbs. per hour
BTU range: 8,200 to 50,000
Approved installations: mobile home, alcove, con-
ventional
PREPARATION
Factory packaging must be removed, and some
minor assembly work is required prior to installa-
tion. Access to the rear of the stove is necessary.
NOTE: Normally, your dealer will perform these
functions.
CLEARANCES
The Breckwell SSP2700 Freestanding has been
tested and listed for installation in residential, mo-
bile home and alcove applications.
FLOOR PROTECTION: Freestanding installa-
tions, minimum 24" wide by 29" deep. The stove
must be placed on a continuous (grouted joints)
noncombustible material such as ceramic tile, ce-
ment board, brick, 3/8" millboard or equivalent, or
other approved or listed material suited for fl oor
protection. NOTE: ceramic tile, or any tile, re-
quires a continuous sheet beneath to prevent the
possibility of embers falling through to the com-
bustible fl oor if cracks or separation should occur
in the fi nished surface, this would include fl oor
protection for Built-in raised hearths. Check local
codes for approved alternatives.
Clearances are measured from the sides, back
and face (door opening) or stove body (refer to
fi g. 3).
DO NOT USE MAKESHIFT MATERIALS OR
COMPROMISES IN THE INSTALLATION OF
THIS UNIT.
INSTALL VENT WITH CLEARANCES SPECI-
FIED BY THE VENT MANUFACTURER.
6

INSTALLATION

INSTALLATION
FIGURE 1
FIGURE 2

FLOOR PROTECTION

(MINIMUM 24" W X 29" D)
FIGURE 3