Table of Contents
Advertisement
Quick Links
Owner's Instruction and Operation Manual
Model Number:
Report Number: F20-603
Tested Per EPA Methods ALT-125, ASTM E2515, ASTM
E3053 and CSA B415
Certified to UL 1482-2011 (R2015) and ULC-S627-00-REV1
Approved for mobile home installation in the USA Only
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For your
safety, follow the installation instructions. Never use make-shift compromises during the
installation of this heater. Contact local building or fire officials about permits, restrictions
and installation requirements in your area. NEVER OPERATE THIS PRODUCT WHILE
UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
© 2021 Breckwell Hearth, South Pittsburg, TN 37380
SW2.0
R
Save These Instructions In A Safe Place For Future Reference.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to
PH. 423-403-4031
853760D-1805K
www.P65warnings.ca.gov
Advertisement
Table of Contents
Related Manuals for Breckwell SW2.0
Summary of Contents for Breckwell SW2.0
- Page 1 State of California to cause emissions standards. cancer, birth defects, and/or other reproductive harm. For more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2021 Breckwell Hearth, South Pittsburg, TN 37380 PH. 423-403-4031...
- Page 2 INTRODUCTION This manual describes the installation and operation of the Breckwell SW2.0 wood heater. This heater meets the 2020 U.S. Environmental Protection Agency’s cordwood emission limits for wood heaters sold after May 15, 2020. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 15,261 to 63,196 Btu/hr with 1 g/hr and 70% efficiency.
-
Page 3: Installation Checklist
Your wood stove should be installed by a qualified installer only. An NFI qualified Installer can be found at www.nficertified. org/public/find-an-nfi-pro/ For customer service, please contact your Breckwell dealer. COMMISSIONING CHECKLIST This checklist is to be completed in full by the qualified person who installs this unit. Keep this page for future reference. -
Page 4: Unpack And Inspect
HEATER provided. WELD FIREBRICK CONFIGURATION Replace the firebrick as shown in the illustration. AIR DEFLECTOR ASSEMBLY Use the provided screws to attach the air deflector to the rear of the unit. © 2021 Breckwell Hearth... -
Page 5: Installation
Recall that wood stoves produce radiating heat, the heat we roof space, closet or similar concealed space, a floor, or feel when we are close to a wood stove. A wood stove also a ceiling. functions by convection, that is through the displacement © 2021 Breckwell Hearth... -
Page 6: Outside Combustion Air
This type of installation is also required in air tight houses • THE STOVE MUST BE ATTACHED TO THE STRUCTURE and houses with negative pressure problems. You can OF THE MOBILE HOME. purchase this option through your heater dealer. Make © 2021 Breckwell Hearth... -
Page 7: Chimney Connector (Stovepipe)
If you are using a masonry chimney, it must be built in compliance with the specifications of the National Building Code. It must be lined with fire clay bricks, metal © 2021 Breckwell Hearth... -
Page 8: Masonry Chimney
Maintain Floor Protector proper clearance to the structure as recommended by the Airtight Cleanout manufacturer. The chimney must be the required height Door above the roof or other obstructions for safety and proper draft operation. © 2021 Breckwell Hearth... -
Page 9: Combustible Wall Chimney Connector Pass-Throughs
Use this cement to also concentric with and spaced 1” (26 mm) off the chimney seal to the brick masonry penetration. connector by way of sheet metal support plates at both ends of chimney section. Cover opening with and support © 2021 Breckwell Hearth... -
Page 10: Operation
Any type of well seasoned natural wood may be used in your stove, but specific varieties have better energy yields than others. Higher efficiencies and lower emissions generally result when burning air dried seasoned © 2021 Breckwell Hearth... -
Page 11: Testing Your Wood
IMPORTANT that you use DRY WOOD only in your wood in a manner inconsistent with operating instructions in this stove. The wood should have dried for 9 to 15 months, manual. such that the humidity content (in weight) is reduced below © 2021 Breckwell Hearth... -
Page 12: Fueling Instructions
Be considerate of the setting. environment and only burn dry wood. © 2021 Breckwell Hearth... -
Page 13: Air Tubes
NOT RECOMMENDED IN YOUR WOOD STOVE. BUILD FIRE DIRECTLY ON FIREBRICK. • NEVER PUT WOOD ABOVE THE FIREBRICK LINING OF THE FIREBOX. • ATTEMPTS TO ACHIEVE HEAT OUTPUT RATES THAT EXCEED HEATER DESIGN SPECIFICATIONS CAN RESULT IN PERMANENT DAMAGE TO THE HEATER. © 2021 Breckwell Hearth... -
Page 14: Maintenance
• If a chimney or creosote fire occurs, close all dampers • Inspect and clean the glass regularly to detect any cracks. immediately. Wait for the fire to go out and the heater to If you spot one, turn the stove off immediately. Do not © 2021 Breckwell Hearth... -
Page 15: How To Order Repair Parts
Other information that may be needed would be the part number and part description of the item(s) in question. Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact your Breckwell dealer or visit www.Breckwell.com Model Information Model Number Dealer’s Name... -
Page 16: Wiring Diagram
DANGER: SHOCK HAZARD DISCONNECT POWER SOURCE BEFORE INSTALLATION AND WHENEVER SERVICING BLOWER ASSEMBLY. NOTICE: DO NOT ALLOW THE POWER CORD TO TOUCH HOT SURFACES! KEEP THE POWER CORD AT LEAST 12”/30.5CM FROM THE STOVE OR PIPE SURFACES. © 2021 Breckwell Hearth... -
Page 17: Replacement Parts
Wood Store Weldment 29360 Shield 611005 Right Side IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING BRECKWELL PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM BRECKWELL. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2021 Breckwell Hearth... - Page 18 Pumice Firebrick (4-1/2 X 9) 891414A Half Firebrick IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING BRECKWELL PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM BRECKWELL. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2021 Breckwell Hearth...
-
Page 19: Service Record
Engineer Name: _________________________________ Engineer Name: _________________________________ License No.: _____________________________________ License No.: _____________________________________ Company: ______________________________________ Company: ______________________________________ Telephone No.: __________________________________ Telephone No.: __________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: __________________________________ Items Replaced: __________________________________ © 2021 Breckwell Hearth... - Page 20 NOTES © 2021 Breckwell Hearth...
- Page 21 NOTES © 2021 Breckwell Hearth...