Page 1
Failure to follow these instructions could result in property damage, bodily injury, or even death. Save these instructions PROFESSIONAL INSTALLATION IS HIGHLY RECOMMENDED Manufactured by National Steelcrafters of Oregon, Inc. DBA Breckwell Hearth Products Eugene, Oregon Grand Prairie, Texas BRECKWELL HEARTH PRODUCTS CW-L-001...
During the paint curing process, it will emit a non-toxic smoke. Opening a window near the stove will help this to dissipate. Only High Temp Paint, available from your Breckwell dealer, should be used for touch-ups. We recommend Stove Bright #6309 – Metallic Black.
Check with local building electrical cord underneath, in front of, or officials. over the stove. Breckwell Hearth Products grants no warranty, implied or stated, for the installation or maintenance of your stove, and assumes no responsibility of any consequential...
SAFETY INFORMATION When operating your W3000FS and W3000I, respect basic safety standards. Read these instructions carefully and completely before beginning any installation procedures or attempting to operate the heater. Failure to do so may result in damage to property or personal injury and may void the product warranty.
Several issues must be addressed when selecting a suitable location for your The floor in front of the stove must be protected as W3000 wood stove. Observing required clearances to combustible materials, the shown in figure 2 and as listed below. The floor proximity to a safe chimney, and electrical supply (if optional blower in use) must all protection must also extend 8”...
INSTALLATION INSERT INSTALLATION PROCEDURE FOR MASONRY CHIMNEY NOTE: Although not required, a full length stainless steel liner (UL1770) recommended optimum safety performance. Read entire installation instructions and complete and return the warranty card. Check all required clearances as specified in figure 3. Open or remove the existing fireplace damper.
INSTALLATION PEDESTAL ASSEMBLY – W3000FS W3000I Note: The W3000FS wood stove is heavy. Be prepared to handle Carefully unpack the blower assembly. Determine which side of the weight to avoid damage or injury. Wearing gloves during the stove the power supply will be located. The blower comes installation is recommended.
(MANUFACTURED) HOME WALL(S), FLOOR OR CEILING. INSTALLING THE BRICK PANELS The brick panels will come already installed in the W3000. The following directions are included should you ever need to remove and re-install the brick panels. Wearing gloves is recommended when handling the brick panels.
Some of the things that can affect natural drafting are size and length of the chimney, nearby obstructions, and geographical location. Your Breckwell dealer will be able to help you match your stove to a proper chimney system.
This no longer applies to your new Breckwell stove. It is still important to have the stove hot enough to burn efficiently, but this will now take less pre-heating than older stoves.
During every chimney cleaning the ceri-blanket should be inspected. If it has become compressed or heavily stained it needs to be replaced. GASKETS Periodically check the door gasket to make sure it is not over compressed (causing the door to leak). Your Breckwell dealer can supply you with the correct gasket for replacement. Never use substitute materials.
REPLACEMENT PARTS Contact an Authorized Breckwell Pellet Stove Dealer to obtain any of these parts. Never use substitute materials. Use of non-approved parts can result in poor performance and safety hazards. ITEM PART # Blower Kit – W3000FS – Optional AW-3000FS-BLWR Blower Kit –...