Kioti NX4510 Owner's Manual page 169

NX4510/NX5010/NX5510/NX6010
3. To keep the plowing depth shallow,
put the draft control lever to the
rear (shallow) position.
The plowing depth tends to become
deeper naturally by outer condi-
tions. When the load increases by
the increase of the plowing depth
while the draft control lever is set
to the "Shallow" position, the plow-
ing depth is maintained as shallow
because the reaction force is trans-
ferred to the internal system via the
top link and the lifting arm is auto-
matically lifted.
4. To keep the plowing depth deep,
put the draft control lever to the
front (deep) position.
5. The position of the draft control
lever should be different based on
the condition of soil to keep the
plowing depth constant.
When working on a new field, it is
recommended to put the draft con-
trol lever to the proper position for
the desired plowing depth and lock
the lever with the lock bolt.
6. When using an implement which
requires no draft function, such as a
rotary tiller and mower, use the high-
est hole on the top link and put the
draft control lever in any position.
7. However, if the draft control lever
is pushed forward to its end, the
lowest position of the lifting arm
can be lowered a little. On the oth-
er hand, if the lever is pulled back
to its end, the highest position of
the lifting arm can be raised a little.
CAUTION
• If the lifting arm is properly
operated but abnormal noise
is still heard, the hydraulic
system may be malfunction-
ing. In this case, let the engine
idle for an 10 to 15 minutes ad-
ditionally and then try to start
the engine again. If the prob-
lem is still present, contact
your local KIOTI Dealer.
CAUTION
e
The implement may shake up
and down as the draft sensor
is under impact when the trac-
tor is passing over irregular
ground with the middle or low-
est top link hole selected. In
this case, put the draft control
lever to the "Deep" position
to decrease the sensitivity of
the draft function or select the
highest top link hole.
• If the tractor has been stored
for a long period of time or
the transmission fluid is just
changed, abnormal noise may
be heard and the hydraulic
lifting arm may be inoperable
temporarily. In this case, let the
engine idle for 3 to 4 minutes.