Table of Contents
Advertisement
7800 Series
Mortise Lock with PT Paddle Trim
Installation Instructions
7
7800 PT Multi Function Lock Instructions
a
How to Change Function of Lock
The green catch screw must be located as
designated on lock case to create desired function.
3 locations:
•One for 05, 37 & 38 functions
(15 function in unlocked position)
•One for 04, 06, 13, 17 & 31 functions
•One for 36 function
NOTE: When moving green catch screw to 04, 06,
13, 17 & 31 functions, hub position must be at
45° as shown on lockcase.
NOTE: 17 function requires both levers to be rigid.
Rotate red locking piece 90°, so red surface of
slide faces back of lockbody.
7800PT lockbody is required when using PT pad-
dle trim, 8200 lever lockbody will not function
properly with the PT trim
b
Items Needed to Create Each of the Following Functions
#41 Cylinder is standard for both single & double cylinder functions for 1-3/4" thick door
NOTE: Trim-one-side functions always require an inside trim assembly which can be used on the
inside or outside of the door
1-800-727-5477 • www.sargentlock.com
Copyright © 2011, 2020, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
Outside
Function
Inside Lever
Lever
04
X
X
05
X
X
06
X
13
X
17
X
X
31
X
36
X
37
X
X
38
X
X
Trim One
Outside
Inside
Side Kit
Cylinder
Cylinder
X
X
X
X
X
X
X
X
X
X
X
X
X
X
5
Thumb Turn
X***
A8130D 02/20
Advertisement
Table of Contents
