Table of Contents
Advertisement
dataFEED edgeGate - Quick Startup Guide
2
Hardware installation
2.1
Mounting and dismounting
Note
Make sure the dataFEED edgeGate is mounted in a manner that the power
supply disconnecting device or interrupt facility can always be reached easily.
Note
Depending on the installation position, the maximum ambient operating
temperature may differ. Refer to
Installation and inspection
Installation and inspection tasks are to be carried out by qualified personnel
only, i.e. personnel qualified according to TRBS 1203 or similar! The definition
of terms can be found in IEC 60079-17.
Mounting
1.
For mounting the dataFEED edgeGate on a DIN rail (35 mm), attach the two upper
notches to the rail.
2.
Press the device down towards the rail until it locks into place.
8
Technical Data
for detailed information.
Copyright 2017 Softing Industrial Automation GmbH
Advertisement
Table of Contents
Need help?
Do you have a question about the dataFEED edgeGate and is the answer not in the manual?
Questions and answers