Toro Groundsmaster 7200 Series Operator's Manual page 46

Figure 121
50. Lower the floor jack until the front wheels support the
frame.
51. Install the flat washers (1/2 inch) and locknuts on the
bogie pivot stud (Figure
(75 ft-lb).
Note: You may need to move the floor jack to the rear
bumper to raise the rear of the machine high enough to
install the flat washer and locknut.
52. Install the side-access covers with the screws previously
removed (Figure 122).
Figure 122
1. Access covers
53. Install the winter frame floor plate cover to the floor
with the screws previously removed
121) and torque to 102 N-m
(Figure 123).
1. Floor-plate cover
54. Connect the cab pressure and return hoses to the quick
couplers on the rear-frame mount
g028090
1. Pressure hose
55. Remove the cap and plug the cab wiring harness
connector into the harness on the rear frame mount.
56. Start the machine, run the lift arm up and down, and
check for hydraulic leaks.
57. Check the antifreeze level and replenish it as required.
46
Figure 123
2. Mounting screws
(Figure 124).
Figure 124
2. Return hose