Toro Groundsmaster 7200 Series Operator's Manual page 42

Figure 105
1. Drive shaft
Note: If the rear of the cab is not high enough to clear
the control handles, evenly tighten the jacking bolts
on each side of the cab jack tube to raise the rear of
the cab (Figure 106).
Figure 106
1. Jacking bolts
28. Route the hoses as follows:
•
Route the tank hose under the lift cylinder and
between the cylinder mounting brackets to the
valve (Figure 107).
•
Route the pressure hose along side the PTO shaft
to the valve (Figure
Note: To emphasis the hose routing, the hoses are
shown without the hose covers installed.
2. Frame tube
107).
1. Tank hose
29. Connect the drive shaft to the gear box shaft in the
winter frame and torque the bolts (5/16 inch) to 20
to 25 N-m (175-225 in-lb).
30. Install the roll pin
2, 3
G016205
1. Pressure hose
2. Tank hose
3. Hose cover
31. With the winter frame against the rear frame, raise the
floor jack enough to remove the summer drive tires
(Figure 109).
42
G016166
Figure 107
2. Pressure hose
(Figure 108).
6 5
1
Figure 108
4. Cable tie
5. Bolts
6. Roll pin
4