Toro Groundsmaster 7200 Series Operator's Manual page 37

Figure 85
1. 3 mounting bolts (3/4 inch), washers, and nuts (left side)
39. Remove the lift cylinder pins and rear drive tires (if
required) to gain access to the bolts on the right hand
side.
Note: Torque the bolts to 360 N-m (265 ft-lbs).
40. Remove the fasteners securing the vertical tube
support assemblies to the rear of the deck frame or
the conversion brackets.
41. Remove the conversion brackets from the deck frame,
if applicable.
42. Pivot open the floor plate
Figure 86
1. Floor plate
43. Slide the drive shaft onto the gearbox shaft
87). Install the roll pin and torque the bolts to 20 to
25 N-m (175 to 225 in-lb).
1
g028364
(Figure 86).
1
g029094
(Figure
1. Drive shaft
2. Gear box
44. Route and connect the hydraulic pressure and tank
hoses to the valve
2
1. Control valve
2. Tank hose
45. Install the rear of the deck lift cylinder onto the pivot
pin and secure with the retaining ring
46. Secure the front of the lift cylinder to the mower frame
with the cylinder pin and screw
37
Figure 87
3. Bolt
4. Roll pin
(Figure 88).
1
g028363
3
Figure 88
3. Pressure hose
(Figure
(Figure 89).
89).