Toro Groundsmaster 7200 Series Operator's Manual page 34

Figure 74
1. Access covers
7. Remove the 1/2 inch locknut and flat washer from the
left and right bogie pivot weldment to unlatch the pivot
(Figure 75).
Figure 75
1. Washer and nut on the bogie-pivot stud
8. Position a suitable floor jack under the center of the
front lift-arm pivot tube.
9. Raise the floor jack until the rear of the machine is
supported on the jack stands and the center tire swings
back and nearly contacts the rear tire.
10. Remove the center and rear wheels from each side.
11. Lower the floor jack until the bogie-pivot weldment
moves enough so that the 1/2 inch flat washer and
locknut can be installed on the stud and threaded finger
tight on both sides of the machine
12. Raise the floor jack high enough so that the track can
13. Repeat the procedure on the other side of the machine.
14. Move the tracks away from the machine.
15. Place an additional jack stand under front of machine.
16. Place a drain pan under the control valve.
17. Disconnect the tank hose from the control valve hard
1. Pressure hose
18. Cap the hose and fitting. Pull the tank hose back
19. Disconnect the pressure hose from the control valve
20. Cap the hose and fitting.
21.
22. Unplug the cab harness connectors, tie down the loose
23. Disconnect the pressure and return quick coupler
(Figure 75).
34
be slid off the front tire.
CAUTION
The track guides have many pinch points.
Coming into contact with one of these pinch
points could cause severe personal injury.
Carefully grasp the rubber track on the outer
edges outboard of the steel guides when
moving the track.
line (Figure 76).
1
2
Figure 76
toward the rear of the frame.
(Figure 76).
Pull the hose back toward the rear of the frame.
cables, and install the cap onto the connector.
hoses from the cab (Figure
G009488
2. Tank hose
77).