Toro Groundsmaster 7200 Series Operator's Manual page 24

Figure 45
1. Drive shaft
8. Route the hoses as follows:
•
Route the pressure hose under the lift cylinder and
between the cylinder mounting brackets to the
valve (Figure 46).
•
Route the tank hose along side the PTO shaft to
the valve (Figure
Note: To emphasize the hose routing, the hoses
are shown without the hose covers installed.
Figure 46
1. Tank hose
9. Connect the drive shaft to the gear box shaft in the
winter frame and torque the bolts (5/16 inch) to 20
to 25 N-m (175-225 in-lb).
10. Install the roll pin (Figure
2. Frame tube
46).
G016166
2. Pressure hose
47).
2, 3
G016205
1. Pressure hose
2. Tank hose
3. Hose cover
11. With the winter frame against the rear frame, raise the
floor jack enough to remove the summer drive tires
(Figure 48).
1. Summer-drive tire
12. Install the winter tires with 2 lug nuts per side.
13. Adjust the floor jack to line up the 2.5 cm (1-inch)
holes in the frame and install a coupler pin on each
side (Figure 49).
24
4
6 5
1
Figure 47
4. Cable tie
5. Bolts
6. Roll pin
Figure 48