Toro Groundsmaster 7200 Series Operator's Manual page 41

Note: Retain 4 of the bolts for installation and store
the remaining for summer change over.
Note: Raise or lower the floor jack to ease removal of
the bolts. Lower the floor jack completely once the
bolts are removed.
Figure 101
1. 3 mounting bolts (3/4 inch), washers, and nuts (left side)
Figure 102
1. 2 mounting bolts (3/4 inch), washers, and nuts (right side)
24. Roll the mower deck and frame forward and out of
the way.
25. Loosen the pressure hose fitting at the pump and rotate
the fitting 45 degrees toward the front of the machine
(Figure 103).
Note:
Figure 103 is shown as viewed from under the
traction unit.
1
g028364
g028365
1
1. Pump
26. Remove the 2 screws securing the winter frame floor
plate cover to the floor and remove the plate
104).
1. Floor-plate cover
27. Carefully roll the winter frame assembly into position
while routing the drive shaft through the frame tube
(Figure 105).
41
Figure 103
2. Pressure-hose fitting
(rotated 45 degrees)
Figure 104
2. Mounting screws
(Figure