Toro Groundsmaster 7200 Series Operator's Manual page 13

2
1
Figure 9
1. Bulkhead bracket
2. Left, rear frame mount
3. Locate the 4 heater hoses, the male and female quick
disconnect fittings, the 2 straight nipple couplers, the
2 R clamps, 2 hose clamps, the dust cap, and the dust
plugs.
4. Assemble the male quick disconnect fitting, the dust
cap, and a straight nipple coupler to the correct heater
hose using a hose clamp.
Note: For machines with Yanmar engine use the 86.3
cm (34 inch) hose. For machines with Kubota engines
use the 57.1 cm (22.5 inch) heater hose. This is the
pressure hose.
5. Assemble the pressure hose onto the bulkhead bracket
in the left position using an R-clamp, a carriage bolt
(1/4 inch), and a nut (1/4 inch)
6. Assemble the female quick disconnect fitting, the dust
plug, and a straight nipple coupler to the correct heater
hose using a hose clamp.
Note: For machines with a Yanmar engine use the
86.3 cm (34 inch) heater hose. For machines with
Kubota engines us the 132 cm (52 inch) heater hose.
This is the return hose.
7. Assemble the return hose onto the bulkhead bracket
in the right position using an R-clamp, a carriage bolt
(1/4 inch), and a nut (1/4 inch)
3
g028356
3. Self tapping screw
(Figure 10)
(Figure 10).
3
4
1. Quick-disconnect coupler
2. Dust plug
8. Place a suitable drain pan under the radiator and drain
the radiator.
9. Cut the lower radiator hose in half on the white line as
shown in Figure
Note: For Kubota machines the hose is located on the
right side of the machine. For Yanmar machines, it is
located on the left.
1. Lower radiator hose
10. Install the tee fitting into the hoses and secure with
hose clamps as shown in
Note: For machines with Kubota engines, the hose
barb is to point rearward toward the radiator fan
shroud.
13
2
Figure 10
3. Nipple coupler
4. Dust cap
11.
Figure 11
2. White line
Figure 12 and Figure
1
g028357
13.