Toro Groundsmaster 7200 Series Operator's Manual page 44

Figure 113
1. Jacking bolts
37. At the rear mounting points, secure the cab to the
machine with a bolt (1/2 x 3 inches), steel washer (1/2
x 2–1/2 inches), rubber washer (1/2 x 2–1/2 inches)
and nut (1/2 inch) (Figure
Note: Tighten all 4 cab mount bolts until the rubber
mounts are compressed to a thickness of 2.2 cm (7/8
inch).
Figure 114
1. Rubber mount
38. Tighten the bolts and nuts securing the rear cab mounts
to the ROPS posts
Note: Adjust the floor jack if the bolts are binding and
difficult to remove.
2. Cab-jack tube
114).
2. 2.2 cm (0.875 inch)
(Figure 115).
1. Cab mount
2. ROPS post
39. Loosen the jacking bolts and remove the cab-jack tube
from the cutouts in the cab floor
1. Jacking bolts
40. Connect the hydraulic pressure hose to the valve hard
line and the tank hose to the valve
Note: Retain the hose plugs for the summer change
over.
Note: Make sure that the hoses are not kinked or
rubbing against any moving parts.
Note: Adjust the angle of the fittings to accommodate
the routing of the hoses.
44
Figure 115
3. Bolts and nuts
4. ROPS post
(Figure 116).
Figure 116
2. Cab-jack tube
(Figure 117).