Toro Groundsmaster 7200 Series Operator's Manual page 23

Figure 41
1. Washer and nut on the bogie pivot stud (2)
3. Insert a block of wood between the front bogie stop
and the frame to tilt the winter frame toward the rear
(Figure 42).
Figure 42
1. Block of wood
4. On the traction unit, install hose covers onto the loose
hydraulic pressure and tank hoses and secure them
with 2 cable ties each.
5. Loosen the pressure-hose fitting at the pump and
rotate the fitting 45 degrees toward the front of the
machine (Figure 43).
Note:
Figure 43 is shown as viewed from under the
traction unit.
1. Pump
6. Remove the 2 screws securing the floor plate cover to
the floor and remove the plate
1. Floor plate cover
7. Carefully roll the winter-frame assembly into position
while routing the drive shaft through the frame tube
(Figure 45).
23
Figure 43
2. Pressure hosed fitting
(rotated 45 degrees)
(Figure 44).
Figure 44
2. Mounting screws