Toro Groundsmaster 7200 Series Operator's Manual page 28

Note: The inner edge of the forward legs of the foam
pieces should be approximately 0.32 cm (1/8 inch)
away from the inner edge of the side-sealing panels of
the cab frame.
3. Align the innermost edges of the left, middle and right,
middle foam pieces with the left, rear and right, rear
foam pieces and interlock the tabs
Note: The inner edge of the forward legs of the foam
pieces should be approximately 0.32 cm (1/8 inch)
away from the inner edge of the side-sealing panels of
the cab frame.
Figure 59
Rear end of the cab
1. Left, middle foam piece
2. Left, rear foam piece
3. Rear, foam piece
4. Align the innermost edges of the left, tank and right,
tank foam pieces with the left and right middle foam
pieces and interlock the tabs
Note: The inner edge of the forward legs of the foam
pieces should be approximately 0.32 cm (1/8 inch)
away from the inner edge of the side-sealing panels of
the cab frame.
5. Press the forward edge of the left, side and right, side
foam pieces against the channel and interlock the
angled rear edge of the side foam pieces with the tank
foam pieces (Figure
Note: There may be a small gap between the tank
foam pieces and the angled edge of the side foam
pieces.
(Figure 59).
4. Right, rear foam piece
5. Right, middle foam piece
(Figure 60).
60).
1. Middle foam piece
2. Left, tank foam piece
3. Channel
6. Center the front foam piece on the front panel
61).
Note: The back edge of the front foam piece should
be aligned to the rearmost edge of the front panel of
the cab frame.
7. Press the forward edge of the side front foam pieces
into the front foam piece and align the inner edges of
the foam pieces with the inner edges of the sealing
panels of the cab frame
Front end of the cab
1. Side, front foam piece
28
Figure 60
4. Left, side foam piece
5. Right, side foam piece
6. Right, tank foam piece
(Figure 61).
Figure 61
2. Front foam piece
(Figure