Toro Groundsmaster 7200 Series Operator's Manual page 35

Figure 77
1. Pressure hose
24. Plug the couplers into each other to keep clean.
25. Install the cap and dust covers onto the quick couplers
on the machine.
Note: Make sure that all connectors are clean before
making connections.
26. Remove the 2 bolts (3/4-inch diameter) that attach the
front frame to the rear frame ahead of the drive tire
from each side of the frame
Note: Do not remove the coupler pin at this time.
Figure 78
1. 3/4 inch bolts
27. Install the summer drive tires with 2 nuts per tire
(Figure 79).
2. Return hose
(Figure 78).
2. Coupler pin
1. Summer drive tire
28. Install the center tires on the winter frame.
29. Install the cab jack tube into the cutouts in the cab
floor (Figure 80).
Note: Tighten the jacking bolts until the tapered ends
go through the hole in the floor plate and just contact
the frame.
1. Jacking bolts
30. Remove the front jack stand and lower the front of
the machine onto the tires.
31. Move the floor jack to the rear of the machine and
lightly support the rear of the machine at the rear
bumper.
32. Remove the bolts and nuts securing rear cab mounts to
the ROPS posts
Note: Adjust the floor jack if the bolts are binding and
difficult to remove.
35
Figure 79
Figure 80
2. Cab jack tube
(Figure 81).