Toro Groundsmaster 7200 Series Operator's Manual page 36

Figure 81
1. Cab mount
2. ROPS post
33. Loosen the 2 front cab mounting bolts so the cab can
pivot freely.
34. Raise the rear of the cab high enough to clear the back
of the seat by slowly and evenly tightening the jacking
bolts (Figure 82) on each side of the cab jack tube a
little at a time.
Note: Alternate frequently from side to side so that
the bolts support the cab evenly and stay in position in
the holes in the floor plate.
Figure 82
1. Jacking bolts
35. Remove the front jack stand and lower the front of the
machine onto the tires until the coupler pins
83) are loose enough to be removed.
Note: If the pins are tight, rotate the pins while
pulling.
3. Bolts and nuts
4. ROPS post
(Figure
1. Coupler pin
36. Carefully roll the front frame away from the rear frame
making sure that the hydraulic hoses and drive shaft
are not hanging up.
Note: Make sure that the rear of the cab clears the
seat and control handles. Adjust the position of the
floor jack if necessary to gain clearance between the
seat and the rear of the cab.
37. Loosen the pressure hose fitting at the pump and rotate
the fitting 45 degrees toward the rear of the machine
(Figure 84).
Note:
Figure 84
traction unit.
1. Pump
38. Roll the summer deck and frame into position and
install the 5 bolts (3/4 inch), washers and nuts that
connect the deck frame to the rear frame
36
Figure 83
is shown as viewed from under the
Figure 84
2. Pressure hosed fitting
(rotated 45 degrees)
(Figure 85).