Sony PMW-1000 Service Manual page 66

XDCAM
Status
SNMP Agent Variables
Community Name
Software Version
Read-only Community
Read-Write Community
Maintenance
Trap Community
Network
SNMP
Communication Hosts
Account
IP Address 1
Setup Menu IP Address 2
IP Address 3
Software Update
Log
Trap Hosts
IP Address 1
Warning
IP Address 2
IP Address 3
Authentication Trap
SNMP MIB-2 Variables
sysDescr
sysObject
sysContact
sysName
sysLocation
Status
Item
Community Read-Only
Name Community
Read-Write
Community
Trap Com-
munity
Communication —
Hosts
IP Address
1/2/3
Trap Hosts —
IP Address
1/2/3
Authentication
Trap
*1: Single-byte alphanumeric characters only. Up to 16 characters can be entered.
PMW-1000
SONY
public
public
none any specific
none specific
on off
PMW-1000
.1.3.6.1.4.1.122.8501
Execute Reset
Setting
public
—
—
—
—
—
—
on
Function
Sets the read-only community name
Used when reading the MIB stored in XDCAM.
Sets the read-write community name
Used when reading or writing the MIB stored in XDCAM
This needs to be set when writing the variables (sysContact,sys-
Name,sysLocation) of MIB-2 of XDCAM from the SNMP man-
ager
Sets the community name of the trap issued from XDCAM
Sets the SNMP Manager with which to communicate using
SNMP
• none: Rejects communication from all SNMP managers
Set this when not using SNMP
• any: Accepts communication from all SNMP managers
• specific: Accepts communication only from the SNMP
manager with the specified IP address
Specifies the IP address of the SNMP manager with which to
communicate when "specific" is selected. Up to three IP ad-
dresses can be specified
Specifies the destination of the trap sent from XDCAM
• none: Does not send the trap
• specific: Specifies the SNMP manager to which to send
the trap
Note
When using SONY-PRO-MIB, select "specific" and specify the
IP address of the SNMP manager
Specifies the IP address of the SNMP manager to which to send
the trap when "specific" is selected. Up to three IP addresses can
be selected
Sets whether or not to issue an authentication trap when there is
an access from a wrong community
• on: Issues an authentication error trap
• off: Does not issues an authentication error trap
Normally, set this to "on"
*1
*1
*1
Continued
3-6