Sony PMW-1000 Service Manual page 57

LOG Alarm message in
status display area
— Copy Aborted.
— Some Clip(s) are
Locked.
— Clip Error.
— Set Appropriate
IN/OUT Points.
— No Clip!
— Cannot Expand Clip
any Further.
— Clip is not Ready.
— Delete is Prohibited.
This Clip is in Use.
— Delete is Prohibited.
Referring EDL is in
Use.
— Delete is Prohibited.
— Lock/Unlock is Pro-
hibited.
This Clip is in Use.
— Lock/Unlock is Pro-
hibited.
— Set Clip Flag was not
Performed.
— One Clip is being Re-
corded.
Use Single Selection.
— Operation is not Sup-
ported for EDL.
— Adding EM was not
Performed.
— Over DUR!
— Cannot Display Chap-
ter of this Clip.
— Chapter was Changed.
Display Again.
— Chapter does not Exist.
— Cannot Expand this
Clip.
— Unable to Parse the
EDL.
— Out of Remain Space!
PMW-1000
Alarm message in video
monitor screen
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
Description/action
The copy operation was aborted.
Some of the selected clips are locked (protected).
The clip is substandard, so the copy operation
failed.
The settings of IN and OUT points for partial copy
operation are not proper.
Check the IN and OUT point settings.
The clip selected for expansion or chapter display
has been deleted.
Alternatively, the memory card has been ejected.
The selected clip cannot be divided any further to
display the expand thumbnails.
This alarm appears when the expand thumbnails of
a clip divided into the maximum number of blocks
are displayed or when the EXPAND function but-
ton has been pressed with the expand thumbnail
screen displayed in which the duration of each
block is one frame.
Chase copy cannot be performed because record-
ing has just started.
Wait until the chase copy function is enabled.
The specified clip is in use, so it cannot be deleted.
The EDL which refers to the specified clip is in
use, so the clip cannot be deleted.
Deletion of the specified clip has failed.
The specified clip is in use, so it cannot be locked/
unlocked.
Lock/unlock of the specified clip has failed.
Set Clip Flag function has failed.
One of the selected clips was being recorded.
To copy a clip which is being recorded, make a
single selection of the clip.
You cannot select EDL to delete an essence mark
or set a shot mark.
Essence mark setting has failed.
A clip with a duration that exceeds six hours cannot
be copied.
The selected clip has failed in chapter thumbnail
display.
Stop recording of a clip if any in progress.
The chapter setting information has been updated.
Try again the chapter thumbnail display.
Chapter thumbnail screen cannot be displayed be-
cause no chapters are set on the clip.
The clip cannot be expanded because it is being
recorded.
The EDL cannot be copied due to existence of an
inhibiting condition such that there is no sub clip.
The remaining capacity of the copy destination
media is not sufficient.
2-9