6-13.
SW-1590 Board
Preparation
1.
Remove the top panel assembly. (Refer to
2.
Remove the bottom assembly. (Refer to
3.
Remove the front assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector on the SW-1590 board.
2.
Remove the screw to detach the SW-1590 board.
PSW2.6 x 6
Harness
Note
When installing the SW-1590 board, fit the boss with the hole.
3.
Install the removed parts by reversing the steps of removal.
PMW-1000
"6-3. Top Panel
Assembly")
"6-4. Bottom Plate
Assembly")
"6-11. Front
Assembly")
Hole
SW-1590 board
Connector
Boss
6-16