Sony PMW-1000 Service Manual page 4

本機をラックに設置するとき
熱の適切な排気 ・ 発散を得るために，ラックと本機の間
には，以下の空間を確保してください。
・上面 2 cm 以上
・左右両側面 2 cm 以上
・後面 25 cm 以上
Attention-when the product is installed in Rack:
1. Prevention against overloading of branch circuit
When this product is installed in a rack and is
supplied power from an outlet on the rack, please
make sure that the rack does not overload the supply
circuit.
2. Providing protective earth
When this product is installed in a rack and is
supplied power from an outlet on the rack, please
confirm that the outlet is provided with a suitable
protective earth connection.
3. Internal air ambient temperature of the rack
When this product is installed in a rack, please make
sure that the internal air ambient temperature of the
rack is within the specified limit of this product.
4. Prevention against achieving hazardous
condition due to uneven mechanical loading
When this product is installed in a rack, please
make sure that the rack does not achieve hazardous
condition due to uneven mechanical loading.
5. Install the equipment while taking the operating
temperature of the equipment into consideration
For the operating temperature of the equipment, refer
to the specifications of the Operation Manual.
6. When performing the installation, keep the
following space away from walls in order to
obtain proper exhaust and radiation of heat.
Top: 2 cm (0.8 inches) or more
Right, Left: 2 cm (0.8 inches) or more
Rear: 25 cm (9.8 inches) or more
PMW-1000
設置時には，通気やサービス性を考慮して設置スペース
を確保してください。
. ファンの排気部や通気孔（左側面および右側面）をふ
さがない。
. 通気のために，セット周辺に空間をあける。
. 作業エリアを確保するため，セット後方は，25 cm 以
上の空間をあける。
机上などの平面に設置する場合は，左側面および右側面
は 2 cm 以上の空間をそれぞれ確保してください。ただ
し，セット上部はサービス性を考慮し 20 cm 以上の空
間を確保することを推奨します。
When installing the installation space must be secured
in consideration of the ventilation and service operation.
. Do not block the ventilation slots at the left side and
right side panels, and vents of the fans.
. Leave a space around the unit for ventilation.
. Leave more than 25 cm of space in the rear of the unit
to secure the operation area.
When the unit is installed on the desk or the like, leave
at least 2 cm of space in the left and right sides.
Leaving 20 cm or more of space above the unit is
recommended for service operation.