Table of Contents
Advertisement
The data shown in these web page views are only
representative of the configuration data required for a
specific interlocking.
interlocking-specific data for that location.
Each TIM must also be configured with specific network-
and SNMP-host interface parameters for that location.
• Enable Terminal Servers – Select "Yes" to enable and view the Table of
Terminal Servers. Typically, only one terminal server needs configured.
• Terminal Server Instance Table
IP Port – Enter the IP port number (1 to 65535) to be used for the incoming
TC/IP connection to the TIM from the network client.
Time to Live – Enter the maximum time (in seconds) that the TIM should
keep this connection open while there is no incoming activity from the network
client. If this time is exceeded, the TIM will close the connection to the
network client.
Duplex – Select "Full Duplex" (typical) for this TIM application.
Modbus Mode – Select "None" (typical) for this TIM application
Serial Driver – Select "Native Linux" (typical) for this TIM application.
Demark IP Packets – Select "No" (typical) for this TIM application.
Echo Cancel RS485 – Select "No" (typical) for this TIM application.
Print Server – Select "No" (typical) for this TIM application.
Number of Servers – Enter the number of clients (eight maximum) that can
connect to this terminal server simultaneously. If set to "1," the terminal
server is preemptive (if a second client connects to this port, the previous
client is disconnected). If set to three (or more), additional connections will be
blocked when the specified number of connections has been made. Select
"1" (typical) for this TIM application.
Password – (Optional) Enter a password (15 characters maximum) for the
terminal server connection. When set, the connection is dropped if the
password (case-sensitive) is not entered within one minute of the password
prompt.
Copyright 2019
NOTE
Each TIM must be configured with
SM-1H1.0002 Rev. 2, March 2019
TransPortalTM Interlock Monitor
4-10
Advertisement
Table of Contents
