Table of Contents
Advertisement
B-2
APPENDIX B Configuring and Updating the SP-II TPU
B.2 Querying or Changing the SP-II TPU IP Address
The SP-II TPU IP address is set up at the factory. However, should a different
address be required, it can be changed.
To change the SP-II TPU IP address:
Connect the supplied configuration cable to the NAV connector of the
1.
SP-II TPU and to an available serial port on the laptop computer using the
supplied USB/RS-232 converter.
2. Turn on the laptop computer and wait for the Windows desktop to appear.
3. Turn on the SP-II TPU by switching the A/C-D/C switch to A/C for AC operation
or to D/C for DC operation.
4. Start Linux TPU Updater.
The Klein Linux TPU Updater dialog box opens.
5. Click Read TPU IP Address .
The Select RS-232 Port dialog box shown in Figure B-2 opens.
6. From the Port drop-down list box, select the serial port on the laptop computer to
which the SP-II TPU is connected.
7. From the Rate drop-down list box, select the baud rate of the SP-II TPU's NAV
serial port, or select Determine Automatically to have Linux TPU Updater find
the rate.
The Klein Linux TPU Updater dialog box opens with the current IP address
displayed in the
Series 3900 Sonar System Operations and Maintenance Manual
The Select RS-232 Port Dialog Box.
Figure B-2:
text box as shown in Figure B.3.
TPU IP Address
P/N 11210085, Rev. 01
Advertisement
Table of Contents
