Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
3
Programming the VoWiFi Handset
This chapter describes how to configure VoWiFi Handsets in two different ways:
•
It is possible to configure the VoWiFi Handset by inserting it into a Desktop Programmer
DP1 cradle connected via USB to the WinPDM.
•
It is possible to configure the basic network settings of the VoWiFi Handset via its Admin
menu. See
made.
The WinPDM enables configuration of one VoWiFi Handset at the time inserted in the Desktop
Programmer (DP1) connected via USB to the administrator's computer.
Tip: It is recommended to use templates when configuring VoWiFi Handsets. By using a
template, the same configuration can easily be applied to many VoWiFi Handsets
simultaneously.
3.1
WinPDM
The WinPDM runs on a PC and is used for configuring the VoWiFi Handset as follows:
•
Connect a DP1 Desktop Programmer cradle via USB to the computer running WinPDM.
•
Start WinPDM.
•
Place the VoWiFi Handset in this cradle connected to WinPDM.
For instructions on how to install and use the WinPDM, see Installation and Operation Manual,
Portable Device Manager (WinPDM), WIndows version, 8AL90832AAAAed02.
Figure 2. Configuration of VoWiFi Handsets via WinPDM
26 June 2012
9 Administration
on page 30 for more information about the settings that can be
2.
Figure
5