Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
7.2.2
Scan a Specific Channel
This gives a list of all the APs found on that channel in the specified SSID.
1
There are two options to access the Site Survey Tool meny:
•
If the VoWiFi Handset has been factory reset or not configured; in idle mode, enter
"40022", select "Site survey tool".
2
Select "Scan selected channel".
3
Enter the channel to be scanned.
4
Select an AP to display information such as SSID, Channel, MAC address, Beacon
period, QoS, and Privacy.
7.3
Range Beep
The range beep function enables a beep to be played whenever the VoWiFi Handset experiences
a filtered field strength of below the configured value (default -70 dBm) from the currently
associated access point. Since the value is filtered, sudden drops in field strength caused by the
environment, for example walking through a door into a room, will be delayed, thus it is
important to walk slowly through the site to cover all weak spots.
7.3.1
Configurable RSSI Threshold
The RSSI threshold of the VoWiFi Handset is set to -70 dBm (default). In the site survey menu
there is the possibility to change the RSSI threshold. This is useful if a specific area is designed
to have another coverage level than -70 dBm.
1
There are two options to access the Site Survey Tool meny:
•
If the VoWiFi Handset has been factory reset or not configured; in idle mode, enter
"40022", select "Site survey tool".
2
Select "Range beep level".
3
Enter the new RSSI threshold and press "OK".
7.3.2
Range Beep on a Configurable RSSI Threshold
A beep is played when the signal goes below the selected threshold.
1
There are two options to access the Site Survey Tool meny:
•
If the VoWiFi Handset has been factory reset or not configured; in idle mode, enter
"40022", select "Site survey tool".
2
Select "Range beep".
3
Select one of the following:
•
On - Activates the range beeps
•
Off - Deactivates the range beeps
26 June 2012
26