Static Ip Address (Manual) Settings; Network Settings; Ssid; Voice Power Save Mode - Alcatel-Lucent OmniTouch 8118 Configuration Manual

Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
6.2.2

Static IP Address (Manual) Settings

1 Select Network > Network A (or B, C, D).
2 In the DHCP mode drop-down list, select "Disable (static mode)". Additional
parameters will be displayed.
3 In the Phone IP address field, enter the unique IP address for the VoWiFi Handset.
4 In the Subnet mask field, enter the subnet mask.
5 In the Default gateway field, enter the IP address for the default gateway.
DNS Server Settings
It is possible to configure which DNS server the VoWiFi Handset shall use. If the primary DNS
server is available, it is always used. Otherwise, the secondary DNS server will be used.
Note: The DNS parameters are only visible if the DHCP mode is set to "Disable (static mode)",
see 6.2.2 Static IP Address (Manual)
Primary DNS Server
1 Select Network > Network A (B, C, or D).
2 In the Primary DNS field, enter the IP address to the primary DNS server.
Secondary DNS Server
1 Select Network > Network A (B, C, or D).
2 In the Secondary DNS field, enter the IP address to the secondary DNS server.
6.3

Network Settings

6.3.1

SSID

The SSID is the name of the network the VoWiFi Handset associates to.
1 Select Network > Network A (B, C, or D).
2 In the SSID field, enter system SSID.
Note that the SSID is case-sensitive.
6.3.2

Voice Power Save Mode

The voice power save mode is used during calls. NONE is recommended to obtain optimal
voice quality. U-APSD uses less power but is more sensitive to network disturbances.
If supported by the infrastructure U-APSD is the preferred choice and multiple the talk time
more than 4 times compared to NONE mode.
1 Select Network > Network A (B, C, or D).
2 In the Voice power save mode drop-down list, select one of following:
• NONE
• U-APSD
26 June 2012
Settings.
15