Actions When Handset Placed In Charger; Configure Profiles - Alcatel-Lucent OmniTouch 8118 Configuration Manual

Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
Note: Changing this parameter may result in lower sound quality and high sound level. Evaluate
carefully before applying.
Headset
Select the headset model that is used.
1 Select Headset > General.
2 Select the applicable item in the drop-down list:
IMPORTANT: Do not select "Hearing protection" unless a Peltor headset is used.
• User model (If not any headset is used above, this option can be used to configure an
own headset profile. If selected, additional configuration is required, see
User
Headset User Model
These settings are required if User model is selected under Headset > General.
1 Select Headset > User model.
2 In the Name of headset field, enter a descriptive name. For example the headset model to
be used.
3 In the following drop-down lists, select the applicable values for the headset:
• Microphone gain
• Speaker gain
• Side tone
Note: Changing the parameters may result in lower sound quality and high sound level.
Evaluate carefully before applying.
6.5.3

Actions when Handset Placed in Charger

It is possible to apply an action for a VoWiFi Handset when placing it in a charger.
In Charger Action
1 Select Device > Settings.
2 In the In charger action drop-down list, select one of the following:
• No action - no action will be performed when VoWiFi Handset is placed in charger
• Change profile - the VoWiFi Handset will change profile when placed in charger.
- In the Change profile in charger drop-down list, select the profile to be used.
- If needed, configure the selected profile, see
6.5.4

Configure Profiles

It is possible to set up an own profile for incoming calls, message alerts, vibrating alerts, key
sound etc. This can be useful when there are many users on the same VoWiFi Handset, and they
want different sound profiles. It can also be used for temporarily settings, for example while in a
meeting, incoming calls should be silent.
Profiles are configured via parameters in the "Profiles" folder.
1 Select "Profiles".
2 Select "Normal" or "Profile X" (where X represents 1- 4)
26 June 2012
Model)
6.5.4 Configure Profiles.
Headset
21