10.2 Display Information - Alcatel-Lucent OmniTouch 8118 Configuration Manual

Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset

10.2 Display Information

The following error messages can be shown in the VoWiFi Handset display:
Display shows
No network.
(The VoWiFi Handset
beeps once a minute with a
low tone followed by a
high tone (during max 30
minutes). If the vibrator is
enabled, it vibrates after
the last beep.)
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown in
English.
Enter PIN code
26 June 2012
Probable cause
The VoWiFi Handset is out
of coverage,
or faulty VoWiFi Handset.
The VoWiFi Handset
cannot find the wireless
infrastructure with settings
matching those configured
in the VoWiFi Handset.
Faulty VoWiFi Handset.
Phone lock is activated.
Action or comment
The beeps can be stopped with the
mute button. Then go into range.
Note: When re-entering the coverage
area it can take a couple of minutes
before the VoWiFi Handset
automatically has registered into the
system.
If this does not work, contact the
system administrator.
1) Check the SSID. The SSID
configured in the VoWiFi Handset
must be identical to the SSID
configured in the system
infrastructure.
2) Check the security settings. The
security settings, that is,
authentication and encryption must
match the settings in the system
infrastructure.
3) Check for 802.11d multi regulatory
domain settings. The VoWiFi Handset
(software version 2.x.x) must be able
to detect in which country it is located
to use the correct channel and
transmit power settings. Later
versions have a parameter specifying
if 802.11d should be used or not. This
is provided by the infrastructure
according to the 802.11d standard.
4) Check which channels are used.
The VoWiFi VoWiFi Handset uses by
default channel 1, 6 and 11. If the
infrastructure is configured to use any
other channel, change it to use only 1,
6 and 11 as this is the recommended
setting.
5) Check that the correct Network (A,
B, C or D) setting is selected.
Select the reset option on the middle
soft key. If this is not available or the
problem persists send the VoWiFi
Handset for service.
Enter the required PIN code. If the
PIN code has been lost, enter a new
PIN code via the WinPDM or do a
factory reset via the WinPDM.
34