Connecting Logo! To A Pc - Siemens LOGO! Series Manual

3.13Connecting LOGO! to a PC

To connect LOGO! to a PC, you need the LOGO! PC cable.
Remove the cover or the program module/card, and connect the cable
there.
Switch LOGO! to PC´LOGO mode
So that the PC can access LOGO!, LOGO! must be in PC ´ LOGO mode.
To switch LOGO! to PC ´ LOGO mode:
1. Switch LOGO! to programming mode:
2. Select 'PC/Card':
3. Press OK
4. Select PC ´ LOGO:
5. Press OK
LOGO! is now in PC ´ LOGO mode, and the following appears on the
display:
PC ´ LOGO
STOP:
Press ESC
The PC can now access LOGO!.
To break the link to the PC, you press ESC.
Switching LOGO! to PC´LOGO mode at startup
1. Switch the power off
2. Remove the cover or the program module/card, and connect the cable
there.
3. Switch the power on
LOGO! goes into PC ´ LOGO mode automatically
LOGO! manual
EWA 4NEB 712 6006-02
Programming LOGO!
, and OK simultaneously
or
or
65