Programming LOGO!
3.8 The golden rules for working with LOGO!
Rule 1
You enter the circuit in programming mode. You switch to programming
mode by pressing the 3 keys ,
You change the values of times and parameters in parameterization mode.
You switch to parameterization mode by pressing the 2 keys ESC and OK
simultaneously.
Rule 2
You enter a circuit in the following sequence:
From output to input
Rule 3
The following applies when entering a circuit:
S
When the cursor appears in the form of an underscore, you can move
the cursor
– Use the keys , ,
– Press OK to select a connnector/block
– Press ESC to exit circuit input
S
When the cursor appears in the form of a solid block, you select a
connector/block
– Use the keys
– Press OK to accept a selection
– Press ESC to go back one step
Rule 4
LOGO! can only store complete programs
40
and OK simultaneously.
and
to move the cursor in the circuit
and
to select a connector/block
LOGO! manual
EWA 4NEB 712 6006-02